5/3/1 Calculator
5/3/1, matched to your plates.
Program settings
The increment uses the selected unit. Assistance loads stay as entered.
Garage inventory uses actual reachable loads instead of this increment.
Beginner TM choices, when entering 1RMs:
“+” allows additional clean reps. Warm-ups are 40% × 5, 50% × 5 and 60% × 3. No extra warm-ups are added on deload.
Assistance exercises
Add your own assistance after the prescribed work. These are your customizations, not extra TM formulas. Assistance is omitted on deload.
Garage plate loading
Counts are matching pairs. An empty list is a valid bar-only setup. Example inventories must be adjusted to match your equipment.
Advance cycle
Review all four training maxes before applying changes.
Reset saved planner
Reset clears all maxes, equipment, progression and workout position.
Clear this planner and its saved data?
Full cycle
How the calculator works
This calculator implements the ten supplied 5/3/1 variants. Classic remains the default. FSL excludes warm-ups when choosing the first main-set percentage. Supplemental and assistance work are omitted on deload. Beginner Prep School has six sessions over two calendar weeks; all six must be marked complete before advancing. BBB Challenge uses alternate-lift 50/60/70% across three cycles, then ends. Training max = 1RM × selected percentage / 100. Each programmed weight uses that lift’s training max × the set percentage / 100. Classic defaults to a 90% training max. Beginners starts at 85%, with 80% and 85% shortcuts. Exact targets are retained. TM-based loads round to a selected increment (default 5), unless garage inventory is enabled. The increment is a preference in the selected unit; switching units keeps its numeric value.
Classic main work: Week 1: 65/75/85% for 5/5/5+ reps. Week 2: 70/80/90% for 3/3/3+ reps. Week 3: 75/85/95% for 5/3/1+ reps. Deload: 40/50/60% for 5/5/5 reps. “+” allows additional clean reps.
Inventory loads are balanced on the same bar. Closest ties choose the lighter load. Equivalent configurations prefer fewer plates, then larger plates. Below-bar targets have no loadable weight; targets above capacity show the heaviest available load with a limit notice.
New lb-native plans default to +5 lb for bench and overhead press and +10 lb for squat and deadlift. New kg-native plans use +2.5/+5 kg. The native unit is set when you first enter a max. Later unit switches convert the existing increments and equipment. Your custom assistance and rep prescriptions are saved per program and workout. Your settings stay in this browser. Assistance weights are optional manual loads and are never derived from the main lift’s TM. They are shown as entered without main-bar inventory rounding.